Keil Logo Arm Logo

ULINKpro Accessories

Learning Platform

Accessories help you to connect your ULINKpro to 5V-only targets or to provide electrical isolation between the debug adapter and the target system.

ULINKpro Isolation Adapter

The isolation adapter is an optional accessory which provides electrical isolation between the target system and the ULINKpro debug and trace unit. Electrical isolation is essential when working with systems that may generate high-voltage spikes (for example motor control systems), or where there is no common ground plane. It uses digital isolation technology which enables it to support high-speed debug and trace as well as a wide target voltage range.

ULINKpro Isolation Adapter

Features

  • Provides digital isolation up to 1,000 V (1 KV)
  • High-speed Debug - JTAG (15 MHz) and SWD (20 MHz)
  • Full-speed data trace capture (SWV)
  • Supports instruction trace capture up to 150 Mbps using 2 or 4-pin ETM
  • Enables timing synchronization with optional power measurement probes
  • Wide I/O voltage range 1.8V - 5.5V
  • External power (via USB connector) minimizes power taken from target
  • Supports 10-pin Cortex Debug and 20-pin Cortex Debug + ETM connectors

The isolation adapter replaces ULINKpro's standard 20-pin ribbon cable, and connects to either a 10-pin Cortex Debug or 20-pin Cortex Debug + ETM connector.

Note Note

  • The isolation adapter is not included as standard with ULINKpro. It must be purchased separately.
  • The isolation adapter cannot be used with ULINK-ME or ULINK2.
  • Some Freescale KExxx devices cannot be connected using the Isolation Adapter.

ULINKpro 5 V Adapter

The 5 Volt (5 V) adapter enables ULINKpro to connect to 5 V-only target devices.

ULINKpro 5V Adapter

Features

  • Expands the I/O Voltage range to 1.2 V - 5.5 V to accommodate 5 V-only devices
  • Supports JTAG and SW clock speeds up to 50 MHz
  • Provides full speed data trace capture (SWV)
  • Supports instruction trace capture up to 400 Mbps using 4-pin ETM
  • Supports 10-pin Cortex Debug and 20-pin Cortex Debug + ETM connectors

The 5 V adapter replaces ULINKpro's standard 20-pin ribbon cable, and connects to either a 10-pin Cortex Debug or 20-pin Cortex Debug + ETM connector.

Note Note

  • The 5 V adapter is not included as standard with ULINKpro. It must be purchased separately.
  • The 5 V adapter is required when working with 5 V-only devices.
Keil logo ARM logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

ARM’s Privacy Policy has been updated. By continuing to use our site, you consent to ARM’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.